 |
 |
27-01-09, 01:49 PM
|
#1 |
|
Guest
Posts: n/a
|
8mm Hex head "spline" to borrow?
I All,
I'm trying to get my forks apart to get the lowers powder-coated. I can't get the 8mm Allen head out of the bottom of the forks. I have the impact driver and hammer, but no "straight" allen key. It need to be about 70mm long. Do any of you helpful and generous lot have one I could borrow to get my forks apart? |
|
|
28-01-09, 03:50 PM
|
#2 |
|
Guest
Posts: n/a
|
Re: 8mm Hex head "spline" to borrow?
so is it just a 8 mm allen key u need?
|
|
|
|
28-01-09, 03:53 PM
|
#3 |
|
Guest
Posts: n/a
|
Re: 8mm Hex head "spline" to borrow?
Oh hi,
It was, but I've done it now! I cut the long end of an old allen key of mine, stuck one end in a 8mm socket, and it came off with the ratchet. Have you been to any TV meets recently? I didn't go last night (forks off!) |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using "Pointy" Tensioners in a "Curvy"? | dtr125 | SV Talk, Tuning & Tweaking | 25 | 05-02-09 05:42 PM |
| 8mm Hex head "spline" to borrow? | sam anon | SV Talk, Tuning & Tweaking | 6 | 27-01-09 05:09 PM |
| teh "what you doing this weekend thread"...sponsored by Chesley "Sully" Sullenberger the Third | keithd | Idle Banter | 30 | 18-01-09 11:47 AM |
| Soulkiss Down - "Head on" SMIDSY | SoulKiss | Soho Massive | 11 | 22-01-08 08:49 PM |
| Rideout "Sections" or "Groups" | independentphoto | Bikes - Talk & Issues | 19 | 04-09-07 01:08 PM |
