GSXR front end finished

[650]

I know the lower one can be done by feel, but I noticed anything less than circa 40Nm just had the bars idly flopping side to side, so I dare say "feel" is probably going to end up having the nut around 40Nm whether people know it or not. Just my thoughts on it!

Out of interest, is the thousand swing arm susceptible to play like the 650?

[Bibio]

never played with a thou but i do know the bearings are different sizes. they are the same type of setup though just bigger id/od so might have the slop. you have one so check

[Jayneflakes]

Originally Posted by Bibio

no website as i only sell my stuff on here.

the kit includes:
laser cut stainless steel disc with magnets that attaches to the rear sprocket bolts.
stainless steel swingarm marker plates with a drop bracket for the sensor.
custom sensor with full end to end cable (i had these specially made up) with OEM connector for the loom.

unlike traditional speedo drive installs that run off the front disc mines runs off the rear sprocket.

PM me if you want more details and prices.

This kit is fabulous and beautifully made. It is super easy to fit and works perfectly. I have one fitted and it has never failed.

Originally Posted by ophic

...probably...should...not...criticize... if you... write... every...thing like...this....................................... .................................................. .................................................. ....................... ...

I like your posts. But what is the obsession with ellipses?

...at least my tits are not too big... .!..!.

...and another thing...........

...but please carry on...this entire thread has been an epiphany for me...

...my new desk top...

...I promised not to hold your boobs against you...your bike is my new inspiration...

...I would very much like to know more aboot those sliders, like where I can get some today...

[Blapper]

Funny thread!

650: SWEEEET bike!

[650]

Oh sorry, forgot to reply to that question. They're R&G and come with that bracket you see on the frame. I have to admit they're marginally annoying in that your shin hits them from time to time (if you've got long legs like me) which can be a bit painful! The bike's not been down (touch wood) but I assume they'd take the brunt, I'm thinking of getting carbon corner covers for the tank as I imagine that would get dented if the bike pivoted on the sliders.

[650]

Originally Posted by Blapper

Funny thread!

650: SWEEEET bike!

Thanks dude. Minor niggles to iron out this weekend then happy days!

Originally Posted by 650

Oh sorry, forgot to reply to that question. They're R&G and come with that bracket you see on the frame. I have to admit they're marginally annoying in that your shin hits them from time to time (if you've got long legs like me) which can be a bit painful! The bike's not been down (touch wood) but I assume they'd take the brunt, I'm thinking of getting carbon corner covers for the tank as I imagine that would get dented if the bike pivoted on the sliders.

...fuk the bike...the sliders are to help keep the thing from grabbing you by the leg and tangling up with you when you lowside the bike in a crash...

...I ALWAYS wear moto cross knee guard under me pants when I ride, not to mention proper riding boots, so I don't mind banging me shins around a bit...

...I am assuming you do wear pants when you ride, of course...

[650]

Only on cold days mate, only on cold days