Is it possible to repair cracked fairing?

At the bottom of fairing where it is bolted to the bike i have a crack of about 2-3cm not caused by me but previous owner!
It is not that noticeable unless looked at closely but was wondering if it's possible to get this repaired?

This stuff seems pretty good: http://www.plastexexpress.co.uk/

I bought my lowers with one having 2 big cracks, I simply used a wide tipped soldering iron to seal the joint, then added in a strip of plastic and melted that in to bolster it up.

With some filling, sanding,filling and sanding it came out good.

[andrewsmith]

I'd try and speak to your local motorcycle bodywork shop.
They will be able to make good job of it

Soldering iron and more plastic to melt with some mesh metal to add behind the fairing and it will come up a treat with sanding.

practice 1st on somthing until youve got the nack though. took me a few tries but my vfr fairing is coming up a treat now and theres alot to do.

Cheers for the advice now i know its possible might see how much i would get charged for a body shop to do it!
If it's too expensive might give a shot myself

[Nobbylad]

Depending on how bad it is, I reckon £50-£100. I had my fairing repaired by a local guy. It was smashed to pieces and I'd already got another off ebay when he said he could fix it. True to his word, he did a great job...so now I have a spare

[dizzyblonde]

Top tip if doing a 'fine crack' yourself. Get some apoxy resin and a pin or needle. Apply into the crack in a thin amount, and hold til set. This way you can secure it in the right place before going into plastic padding the back of the fairing.

It works, cause I haz done it