Still got the idle problem

Hi people, thanks for all of the suggestions. Ive striped the choke cable and its all free no problems there but the bike is still reving at 3000, when putting the air filter housing back on i knocked a black/yellow wire off front primary circuit wiring whats connected to the front HT coil, the rev counter stopped working and the bike was idling perfect put the wire back on and it goes straight to 3000revs and the counter works again.
Canj someone pls help its driving me crazy

[Quiff Wichard]

cant help mate but I am surprised no one has been along who can ..

they will do
this is a good place..

wait and patience.



i am rubbish but pie in the sky ideas.

1. could it be a problem with the accelerator cable not the choke cable? or throttle?. or wires passed up to the throttle in wrong way so they are revving when the wheel is turned.
2. is the idle adjustment knob not working properly

I am sure u checked all these.

do you have a Haynes?.. did u connec tthe wire properly back on?

[Quiff Wichard]

I just read the original post by you cos I was intrigued-
I see mr Sid Squid made a comment - he aint usually wrong.

if all else is ok.. it sounds like the bike is on throttle..

have you adjusted the throttle cable adjustment? there are 2 cables ones a return and the nuts to adjust each if i recall.. u prob know this.. mefinks u need take petrol tank off too. ! cant remember maybe lift off the carbs also.

anyway it could just be that- as if you are sat on bike and it idle norm but apply a few revs- if your throttle is not closing down fully .

sorry .. i may be way off the mark but I am bored and lonely.

Hey people it looks like ive been having a blonde moment. After striping the carb down and kicking it across the yard, ive put another new choke cable on.
Guess wot ?
Yep it works fine now, thanks all for your help

Taylor,

ANy chance you could tell where the choke cable is and howbest to replace it?

I've got a similar problem to you, as when I start the engine it idles away at 1500 then when I rev the engine up to 3000 - 4000 rpm it actually sticks at that level.

Originally Posted by gerbrox

I've got a similar problem to you, as when I start the engine it idles away at 1500 then when I rev the engine up to 3000 - 4000 rpm it actually sticks at that level.

If that bike in your avatar is yours, then you're in for a bit of a shocker - there isn't a choke on the FI pointy models. Don't know what the problem is though, so someone with a better idea should be along shortly.

cheerz for that it's not my bike in the avator but its a silverversion K3.

[husky03]

Originally Posted by gerbrox

Taylor,

ANy chance you could tell where the choke cable is and howbest to replace it?

I've got a similar problem to you, as when I start the engine it idles away at 1500 then when I rev the engine up to 3000 - 4000 rpm it actually sticks at that level.

mate-you need to contact shmoo in the scottish section-he'll get your bike sorted-and he's a fellow teddybear

husky

Hmmm - may I ask...


... have you hit it with a hammer yet?

Originally Posted by husky03

mate-you need to contact shmoo in the scottish section-he'll get your bike sorted-and he's a fellow teddybear

husky

Cheers Huskey I'll try him.