sv650s L2 compatible shorty levers?

[redmeat]

ASV Inventions were really helpful. With their permission I'm posting their response verbatim:

The application chart is correct, the 99-19 SV650 takes the BRC520 and CRC530

The install instructions PDF is outdated and needs to be updated but those are the correct part numbers for the SV650

The only thing we ran into is the new 2019 SV650 now takes the GSX-R Tab to activate the Clutch Sensor Switch.

You will receive all the tabs and bushings included in the packaging

[Denc2410]

Great, thanks!

[Red Herring]

I'm slightly biased as it's what I did but the cheapest, strongest and most stock looking way of getting short levers is to just cut the standard ones down! All I did was cut the balls off the ends, cut the levers down to the length I wanted, and then I took the levers and the balls to a local welder and asked them to weld them back on.... It cost me a tenner for both levers. I had to tidy the weld up a little with a file and then some emery paper but you can't even tell it's been done, other than they are shorter......