Bikes - Talk & Issues Newsworthy and topical general biking and bike related issues. No crapola! Need Help: Try Searching before posting |
|
Thread Tools |
20-12-19, 09:06 PM | #1 |
Junior Member
Join Date: Dec 2019
Posts: 14
|
2009 SV won't prime and have CHEC light?
I was adjusting the clutch at the front sprocket the other day and when I was piecing everything back together, it would no longer start. I'm unsure if I knocked anything etc.
When I turn on the ignition, the dash lights up as usual, the tachometer's needle doesn't move (unless I disconnect the battery and reconnect it, which it then goes to 7k rpm and back to 0 only the once). The fuel pump doesn't prime. After about 3 seconds I get a CHEC light. I haven't accidentally forgot about the kill switch, the sidestand switch i'm sure is fine as is the clutch switch. If I try and start it while pulling in the clutch, nothing happens (no cranking). Just my headlights go dim/off. When I tested the voltage from the battery terminals, I got an extra 0.10V as I pressed in the starter button. I have tested the clutch switch itself for continuity and that was fine. I also tested the killswitch which was fine. I tested the sidestand switch and didn't get a beep, but I got some numbers on the multimeter which I assume is the resistance of the circuit (as i tested it from the male plug that normally plugs into the female end under the tank). I have tested all fuses and they're fine. I have also tried a battery out of an R6 to no avail. I also can't seem to get into the dealer mode when bridging the 2 pins, I just have CHEC displayed. |
21-12-19, 08:27 AM | #2 |
Member
Join Date: Mar 2013
Location: At home
Posts: 756
|
Re: 2009 SV won't prime and have CHEC light?
OK just read that properly, so not an accidental on kill switch. What about the starter relay? However I hate electrics, and ain't that good with them, hopefully someone with more knowledge will be along shortly. Good luck.
__________________
Currently driving a Corsa.... Last edited by shiftin_gear98; 21-12-19 at 08:36 AM. |
21-12-19, 01:08 PM | #3 |
Junior Member
Join Date: Dec 2019
Posts: 14
|
Re: 2009 SV won't prime and have CHEC light?
Ahaha no worries. I don’t know how to check it? And I’m somewhat the same. I just don’t have the knowledge about it.
|
21-12-19, 01:32 PM | #4 |
Junior Member
Join Date: Dec 2019
Posts: 14
|
Re: 2009 SV won't prime and have CHEC light?
SO! All fixed. Turns out this bike has an alarm/immobiliser that I was not aware of.
|
21-12-19, 01:45 PM | #5 |
Member
Join Date: Oct 2007
Posts: 537
|
Re: 2009 SV won't prime and have CHEC light?
according to the manual (admittedly not the one for your bike) it can only be the kill switch, ignition fuse or a connection between ECU and speedo unit that brings up CHEC. This will not bring up any fault codes...
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Chec Code question | zombie | SV Talk, Tuning & Tweaking | 5 | 31-10-15 08:49 AM |
Pointy - Chec message? | Fletchmeister | SV Talk, Tuning & Tweaking | 0 | 18-08-12 01:21 PM |
'CHEC' Light on LCD | redeye321 | Bikes - Talk & Issues | 2 | 12-11-09 06:44 PM |
Chec ? | daz311066 | SV Talk, Tuning & Tweaking | 14 | 16-04-08 05:41 PM |
Chec message? | davidimurray | SV Talk, Tuning & Tweaking | 3 | 10-08-07 08:28 PM |