Torque Talk - SV650.org

27-12-04, 08:31 PM

Can anyone help?
I'm trying to find the correct torque setting for my K3 R&G crash bungs. The factory fitted bar was not very tight, so I've only tightened the R&G's to 70Nm. In earlier threads I've seen settings mentioned from 55Nm to 95Nm, but 95 seemed a bit extreme.
Does anyone know the correct setting, please?

27-12-04, 08:33 PM

95 is correct

27-12-04, 08:38 PM

Many thanks.
I will torque it up tomorrow.
Worrying that the factory fitted standard bar was not tight...Many others have mentioned that they had to use extension bars to undo the nyloc nut. Mine came undone with just standard ratchet bars at each side??

27-12-04, 08:31 PM	#1
Stan the Man Guest Posts: n/a	Torque Talk Can anyone help? I'm trying to find the correct torque setting for my K3 R&G crash bungs. The factory fitted bar was not very tight, so I've only tightened the R&G's to 70Nm. In earlier threads I've seen settings mentioned from 55Nm to 95Nm, but 95 seemed a bit extreme. Does anyone know the correct setting, please?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I want to talk to my pillion	tigersaw	Bikes - Talk & Issues	36	21-07-08 09:20 PM
NI Number talk	plowsie	Idle Banter	77	16-07-08 07:01 AM
Talk Talk	RhythmJunkie	Idle Banter	5	15-08-07 11:00 PM
Carb talk	BURNER	SV Talk, Tuning & Tweaking	0	15-06-05 08:48 AM
Will she talk to me?	JohnA	SV Talk, Tuning & Tweaking	3	03-03-05 06:05 PM

27-12-04, 08:33 PM	#2
Flamin_Squirrel Guest Posts: n/a	95 is correct

27-12-04, 08:38 PM	#3
Stan the Man Guest Posts: n/a	Many thanks. I will torque it up tomorrow. Worrying that the factory fitted standard bar was not tight...Many others have mentioned that they had to use extension bars to undo the nyloc nut. Mine came undone with just standard ratchet bars at each side??