This exhaust on the SV?... - SV650.org

06-06-05, 05:08 PM

100mm diameter, 18inch length, 54~mm inlet (same as SV). I would have to weld a pipe at angle of SV exhaust and get a baffle. Still could be cheap. Thoughts?

northwind · 06-06-05, 07:48 PM

What happened to the R1 pipe?

Viney · 06-06-05, 08:10 PM

It will be very loud that size and the carbon will split inside 3 months, other than that, go for it

06-06-05, 08:23 PM

I couldn't get it welded on -alu and steel is a nasty combo without a MIG.

Why will the carbon split within 3 months? Also I intend to get a baffle.

06-06-05, 11:21 PM

I have a Standard Can I cut off a system I purchased from Ebay. It's dented and a little scuffed, but would get you through an MOT. You would need a sleeve to connect it to your downpipes, but these are readily available from ART etc.

If your interested PM me.

Dan.

06-06-05, 05:08 PM	#1
snoopy Guest Posts: n/a	This exhaust on the SV?... 100mm diameter, 18inch length, 54~mm inlet (same as SV). I would have to weld a pipe at angle of SV exhaust and get a baffle. Still could be cheap. Thoughts?

06-06-05, 07:48 PM	#2
northwind Moderator Mega Poster Join Date: Jan 2004 Location: In the garage where I belong Posts: 17,082	What happened to the R1 pipe? __________________ "We are the angry mob, we read the papers every day We like what we like, we hate what we hate But we're oh so easily swayed"

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what exhaust is this?	hovis	Bikes - Talk & Issues	32	25-01-09 07:19 PM
gasoline in my exhaust... fuel in my exhaust	mtb83201	SV Talk, Tuning & Tweaking	5	29-04-08 10:58 PM
Exhaust 4 exhaust swap?	SVnutta!!	SV Talk, Tuning & Tweaking	2	29-06-06 04:26 PM
Which exhaust is best.??	BigLee	Exhausts	31	09-07-05 09:26 PM

06-06-05, 08:10 PM	#3
Viney Member Mega Poster Join Date: Jul 2003 Location: In the shadows to the left Posts: 7,700	It will be very loud that size and the carbon will split inside 3 months, other than that, go for it

06-06-05, 08:23 PM	#4
snoopy Guest Posts: n/a	I couldn't get it welded on -alu and steel is a nasty combo without a MIG. Why will the carbon split within 3 months? Also I intend to get a baffle.

06-06-05, 11:21 PM	#5
Dan_SV Guest Posts: n/a	I have a Standard Can I cut off a system I purchased from Ebay. It's dented and a little scuffed, but would get you through an MOT. You would need a sleeve to connect it to your downpipes, but these are readily available from ART etc. If your interested PM me. Dan.