clutch cable adjustment

[steveg]

Hi ,
Got new chain fitted last week ,at the time asked garage to adjust the clutch cable as there was too much clutch cable play at lever , have ridden for another 500miles & clutch cable play at lever is loose , have ran out of adjustment for clutch cable at handle bar .

I know you can adjust the cable at the bottom end by some lock nuts , is it just a case of winding in clutch cable adjuster at lever & then adjusting the cable as the bottom end lock nuts ?

Do i need to adjust the clutch itself by loosen nut & tighten screw & backing out 1/3 turn or can I just adjust the clutch cable ?

Cheers Steve

[Viney]

Originally Posted by Sid Squid Previously
Slacken off cable adjusters at top and bottom, loosen lifter locknut, back out screw a bit, ensure that lifter arm is as far down as it will go, gently turn screw in until it contacts pushrod, then back it out a bit, (~1/8th of a turn), then nip up the locknut, roughly adjust cable with lower adjuster - not too tight - then with top adjuster, ensure that there remains a little slack all the way from lock to lock.

From the legend himself