GSXR front end speedo conversion sensor

My sensors packed up and i need a new one but i can't remember the link to the svrace shops page and i can't get to it through the main shop page but maybe someone heres got a kit kicking around or can send me the link

Cheers

What sensor was it you were after?

Originally Posted by phil24_7

What sensor was it you were after?

I was after the hall effect pickup but i found one in the uk, fitting it as we speak, half the price of the US version too

Were'd ya get it and how much??

Regards
Phil

Originally Posted by phil24_7

Were'd ya get it and how much??

Regards
Phil

RS do them http://uk.rs-online.com/web/search/s...duct&R=2355706

and i brought some counter sunk magnets from ebay (which i attached with M3 stainless allen bolts and stainless ny-lock nuts to the discs)
like these but smaller http://cgi.ebay.co.uk/NEODYMIUM-COUN...QQcmdZViewItem but check the poles

That's the same sensor as I got from Farnell (cheaper and better service, RS didn't wanna answer any questions about specs or suitability, Farnell took the time to make sure the spec of theirs was the same).

What size were the magnets and which way do the poles need to be (I'm preparing a back-up if mine don't get sorted out from the states)?

Regards
Phil

Originally Posted by phil24_7

That's the same sensor as I got from Farnell (cheaper and better service, RS didn't wanna answer any questions about specs or suitability, Farnell took the time to make sure the spec of theirs was the same).

What size were the magnets and which way do the poles need to be (I'm preparing a back-up if mine don't get sorted out from the states)?

Regards
Phil

I didn't get it from RS cause they were out of stock, i got it from kemptoncontrols.co.uk but its the same make

I cant remember the size of the magnets but the ones from the US kit are fine until you need to change the discs or a magnet falls out

Did you get any spare magnets?

If mine fall through can I pop round and measure yours?

This is the last bit I need to do to complete my gixer conversion.

Originally Posted by phil24_7

Did you get any spare magnets?

If mine fall through can I pop round and measure yours?

This is the last bit I need to do to complete my gixer conversion.

I brought a 10 pack before i found the counter sunk ones so i got them spare, i think there the size for the rotor cups, but i can't remember. Your more then welcome to come over and check

Cheers, will wait to see what happens with mine fist!