 |
 |
28-07-11, 10:27 PM
|
#1 |
|
Guest
Posts: n/a
|
bar ends
after some original oem bar end if anyone has some ?
|
|
|
29-07-11, 12:43 AM
|
#2 |
|
Guest
Posts: n/a
|
Re: bar ends
I just got replacement ones on EBay from Pro Bolt for 20 quid. The ones that were on there were about 2" and (I felt) stuck out too far. The new ones are about 1.5" and feel loads better. They also come with Hex bolts rather than the "toffee" Phillips screws on the originals. And they needed an extra shim to tighten fully.
|
|
|
|
29-07-11, 07:51 PM
|
#3 |
|
Guest
Posts: n/a
|
Re: bar ends
are they the same weight as the oem bar ends, just trying to cut down the vibrations a bit so thought best option is oem ones as they dont seem to do heavy bar ends for curvy as when i was sent some they were for a pointy and had no chance fitting the curcy and then when i complained i was told they are the only ones and they will admend the ad.
charlie |
|
|
|
29-07-11, 07:52 PM
|
#4 |
|
Guest
Posts: n/a
|
Re: bar ends
by any chance u need the old ones? are they the originals?
|
|
|
|
29-07-11, 10:06 PM
|
#5 |
|
Guest
Posts: n/a
|
Re: bar ends
I've got originals, just sold my clip ons but still have the oem bar ends and all the necessary gubbins
 PM me if your interested. Last edited by Chris Bird; 30-07-11 at 10:37 AM. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bar Ends | Kaikoura | SV Talk, Tuning & Tweaking | 2 | 01-05-09 02:41 PM |
| Screws for Bar ends/ bar ends, black screen K3 Pointy | renman8957 | Stuff Wanted | 3 | 06-02-09 06:08 PM |
| new bar ends | Tomcat | Photos | 11 | 23-06-07 10:17 PM |
| bar ends | stooster | SV Talk, Tuning & Tweaking | 25 | 25-02-07 08:43 PM |
| HELP!!! - R&G Bar Ends | krhall | Bikes - Talk & Issues | 5 | 03-02-07 08:21 PM |
