Standard or Cut Exhaust Link (Curvy)

As title, the small bit that the end can attaches too.

Regards

Rory

[Binky]

Not exactly sure what you want here. (Probably me being dumb)

I've got the whole exhaust system that comes from the front cylinder and the rear cylinder but not the actually end can as it was cut for an after market silencer.



I've got all of the bits here apart from the end of part of 14.

Let me know exactly what you need and hopefully i can A.) understand and B.) find the part...

The Part where you cut it for an Aftermarket Exhaust.

I'm after that section... so I can still put on the original can if needed.

IS it the linkpipe your after or the actual clamp ? which u can get on Fleabay http://www.ebay.co.uk/itm/SV650-Stan...item483dc8346c

You don't cut the exhaust silencer off at the very end of the can u cutt it about 2" above the weld

This might help ..

That clamp could help, what I wanted was to take off the standard can without cutting the pipe and get a piece pre-cut for my aftermarket exhaust, so I could just take off the cut part and put the original can back on.

But this clamp solves my problem, didn't know they existed, thanks for the help

Any aftermarket can that's to be fitted needs the original can cut off there , you do get premade link pipes for aftermarket end cans , i also have a spare one you can have for £15 + postage if u want it

Originally Posted by SpikeTM

Any aftermarket can that's to be fitted needs the original can cut off there , you do get premade link pipes for aftermarket end cans , i also have a spare one you can have for £15 + postage if u want it

This Clamp fits the bill for a what I need, it cancels the need for another link pipe rather than detaching the standard can at the nearest joining...

Thanks though