Blue Flame help

Do I need instructions to fit my blue flame or is it really easy?
they emailed me instructions (none with can) but I cant open them on my pc

Ian

[fizzwheel]

Its a piece of p*ss.

Cut original pipe 45mm from the weld, use the clamps to hold the link pipe and end can in place. Fit it all with the clamps loosely done up and then tweak the fitting position of the pipe, once your happy tighten up.

You might have a bit of bother with the can hanger if its a EVO as the can hanger isnt a very good fit, I heated mine up a bent it a little so it was a better fit.

Just take your time and you'll be fine.

Thanks fizzwheel

sounds easy enuf!

Ian

[fizzwheel]

Trust me if I can do it, anybody can

I have heard about the hanger problem and it seems to be a bad fit on mine aswell, gonna make sure that I get it snug cause this leads to them rattling apart I think, which is what most people complain about

Ian

[Viney]

Originally Posted by ian2001

I have heard about the hanger problem and it seems to be a bad fit on mine aswell, gonna make sure that I get it snug cause this leads to them rattling apart I think, which is what most people complain about

Ian

No thats because they are not built well in the 1st place. Other than that, exactly what fizz says. If you want to seal the joints, then basic bathroom silicone sealent is the best.