| beefcake |
12-09-05 08:59 AM |
The Stebel Magnum can be located inside the righthand fairing. You can do it without removing any of the fairing panels. When you look at where the radiator cap is, you can see metal fairing support framework with holes drilled along it. You can use one of the holes to attach the fixing plates the magnum comes with.
Process should be:
You will need to attach an additional bit of wire to the horn as the standard horn connectors will not reach. Attach the two metal plates to the back of the Magnum. Situate the horn inside the right hand side of the fairing using a small nut and bolt. Do it up hand tight only. Move handlebars left and right to ensure the magnum clears the steering damper. Then tighten horn fixing plate to the fairing framework.
You can then run the wires back to the original connector (cable tying it to the fairing framework, and use crimped spaded lugs to push into the original connector. Stick some insulation tape around the join, and the jobs done.
You will find that the original connector will pass over the top of the rad, and by using crimped spaded lugs, you can just disconnect the magnum and re-install the original horn as the original connectors will still be there.
PS Helps if you have small hands!
|
