Re: gsxr front end! Again
 

I would go for 750 k1-k3. Likely to be cheaper. Axial brakes definately cheaper than radials. Negligble difference in performance.

Re: gsxr front end! Again
 

ok well i can get a gixxer 750 front end k3 for £350 (about carnt remeber but around that figure)

Re: gsxr front end! Again
 

That's not bad going.

Re: gsxr front end! Again
 

Just don't forget all the sundries add up to quite a lot too...

...brake fluid...fender...pads...brake lines...various bolts...bearings

Re: gsxr front end! Again
 

it was for the whole lot inc wheel pads,brake lines,fender

Re: gsxr front end! Again
 

I have some of the magnets (brand new) if you need them http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=350118865743

Re: gsxr front end! Again
 

Here's a couple of pictures of mine.

http://i829.photobucket.com/albums/z...andcar2002.jpg

http://i829.photobucket.com/albums/z...andcar2005.jpg

http://i829.photobucket.com/albums/z...andcar2006.jpg

As regards YC's comment on the brake calipers, I found k1-k3 calipers fairly difficult to source (unless paying over the odds) in comparison to later radial ones. The radials don't seem to be that much more money either.

Re: gsxr front end! Again
 

You got a steal my spikey haired friend ;)

Nick

Re: gsxr front end! Again
 

True about the k1-k3 calipers, I'm having a job getting hold of these atm...they are the same as sv1000 calipers tho, also bandit 1250 ones are the same as well I believe

Re: gsxr front end! Again
 

[QUOTE=yorkie_chris;2090198]Problem is that shock is too short. Stock 1gen shock is 337mm, ohlins is 337mm +12 on ride height adjuster and that is still too short!

Shock length of k3 sv is 330mm I believe YC.
I think k3 gixxer 1000 is shorter, k1 and k2 are near identical though, with the same spring rate.

Skyline, sv1000 are the same but even harder to find on ebay.