Oil Change - Now Won't Start.
 

The bike is a 2005 pointy SV650.
I've just changed oil and filter at 8000 miles and ... the fuel pump whirs, the engine spins when I press the button but there's no sign of it firing! I can smell petrol after it's turned over for a while and I've left it in case I've flooded it somehow.
I've checked the kill switch is in the right position and I'm stumped about what I've disturbed that would prevent the bike from running.
Before I start taking things apart, is there anything I'm likely to have messed up?
Thanks
Jeff

Re: Oil Change - Now Wont Start
 

How much oil did you put in?

Re: Oil Change - Now Wont Start
 

is it on a centre / paddock stand and is the side stand down?

Re: Oil Change - Now Wont Start
 

Thanks for the quick replies!
Oil - I've put about 2.5 litres in. Was going to run the engine for a minute then check the level and top it up.
Stand - I'm holding it upright with the side stand up (Sadly my paddock stands are in the garage with another broken bike)

Re: Oil Change - Now Wont Start
 

Sounds like you may of disturbed the coil wire or the pickup


Have you tank off or not?

Re: Oil Change - Now Wont Start
 

No, just oil drain plug, filler and the filter.
I have just taken the pillion seat off and checked the fuses there - all ok.

Re: Oil Change - Now Wont Start
 

thats well odd then, sounds flooded.. trying spinning it over on full throttle

Re: Oil Change - Now Wont Start
 

if it's flooded do ya not just spin it over without any throttle so the engine turns and doesn't get any more fuel? Or have I got it the wrong way round :)

Re: Oil Change - Now Wont Start
 

You need the extra air to try and clear it - its what i do, it should slowly try and catch if its that, or he could pull out front plug and see if its wet, if it is leave it to air then hopefully it will catch on that 1

Re: Oil Change - Now Wont Start
 

fair play. I remember at cadwell when irsky dan was trying to start a cbr600 which should have been broken & sold for parts a long time ago. He managed to get it started but with the throttle pinned fully open it just stuttered constantly at about 2k revs.

I told him to let go of the throttle and hold the starter til it started to tick over normally on its own. Problem solved. Then he tried to rev it.... screaming clutch anywhere above 4k rpm lol. It stayed in the van that day!

Is there any chance the OP has left the bike in gear and the sidestand switch has failed maybe?

Re: Oil Change - Now Wont Start
 

OK, thanks! Turning it over with the throttle open full did the trick :) Why it had flooded in the first place I don't know but the main thing is that I don't have to get the car out this evening!
Cheers all
Jeff

Re: Oil Change - Now Wont Start
 

Yay glad its sorted


and glad i got something right :)

Re: Oil Change - Now Wont Start
 

Re: Oil Change - Now Wont Start
 

he he honestly i promise its rare that i get stuff right :smt016

Re: Oil Change - Now Wont Start
 

Woohoo, im coming to you for advice from now on

Re: Oil Change - Now Wont Start
 

Glad it ended up being something as simple as that. Happy riding :D

Re: Oil Change - Now Wont Start
 

I've had this dilema for a bit of a while now actually...

It goes "eenie meanie miny mo, pull the tiger by it's toe, if he growls let him go, eenie meanie miny ?????" ... really struggling with it.

Re: Oil Change - Now Wont Start
 

For info, most (?) FI systems have a fuel inhibit on full throttle cranking, just for this purpose. I don't know for sure whether the SV does, but most cars do.

With carbs it usually works (but not always) because the gas speeds are so low on cranking that the fuelling goes very weak on full throttle cranking. Depends on the carbs.

Re: Oil Change - Now Won't Start.
 

Out of interest Embee why do FI systems have that when it shouldn't be possible to flood them?