Recommend me an adhesive
 

My magnets that run my speedo conversion keep falling of my brake discs, i can't use the holders that come with the kit because they don't fit the wavy discs i got :roll:

I used araldite but that obviously didn't work, what would be best?

Re: Recommend me an adhesive
 

Blimey mate,
If Araldite didn't work you didn't use it properly. Cos it has always worked long term for me.
John

Re: Recommend me an adhesive
 

It was the "rapid" stuff, i don't think its as strong as the real one

Re: Recommend me an adhesive
 

YOu might be right.

Give the trad araldite a go.

IN truth it has never quit on me and we go back a long way. lol!
JOhn

I've found Araldite Rapid to be fantastic. One of the ally lugs on the swingarm (that hold on the chainguard) is stuck on using the Rapid version, it's now done a good 5k miles since, and is as solid as a rock. I can't underline the need for good preparation: both surfaces should be slightly roughened, to give a good "key", and be totally grease free (even a fingerprint can make the difference between success and failure).



.

Drill the disc and put a bolt through, maybe? Assuming the magnets are the same as mine anyway...

I used different magnets for teh Veypor, they were always falling off so I dilled a very shallow hole into the disc, just enough to sit the magnet slightly into. Big difference...

How on earth did you snap a lug in the 1st place?

Ah, yes, cos I'm a numpty :lol: . Couldn't get one of the two screws undone, so I used a hammer on the end of the screwdriver and tried to bang/twist it undone, and yes I found out the ally lug didn't like this, cos it fractured and fell off :oops: . Still, you've got to learn... :-dd


.

Ah. And theres me thinking you where a sensible chap ;)

I gave the magnets to TSM as i didn't need them for the wavy discs and magnets are cheap enough off ebay (20x 8mm dia x 3mm = £5.45 :D )

That might be the way forward :wink:

if you cant mend it j b weld it!!!!



try j b weld on it its available from halfrauds.



JB Weld
JBWELD

Don't Scrap it
J-B Weld it!





Tensile strenght 4000 psi after 24 hours
Resistant to constant temperature up to 300 c
Pliable for upto 25 minutes
Permanently bonds metal, plastic, ceramic, wood, masonary
can be drilled, filled, sanded, machined, tapped and painted
25 year shelf life once opened blah blah blah