|
Tail Tidy Help!
hey i know this is probably been answered but I havent been able to find where! Just ordered a tail tidy for my SV and in the description it says it is a direct replacement for my old one. But I cannot see where it is held on to the undertray. I have looked but maybe Im being a typical youngster and giving up after 5 mins :confused: Any help would be greatly appreciated.
|
Re: Tail Tidy Help!
what make is it?
i know the curvy you have to cut the old one off, not sure about a pointy |
Re: Tail Tidy Help!
|
Re: Tail Tidy Help!
Quote:
does that help? |
Re: Tail Tidy Help!
Yeah thats what I cant see? Maybe Im just been thick? Has anyone got a pic of where it bolts in?
|
Re: Tail Tidy Help!
If you are a beginner than the Tail tidy on pointy can be a pain in the **** to fit.
Have a look at this web site: http://www.hamicad.co.uk/SV_Fender/S...ions%20new.pdf Hope that helps:D |
Re: Tail Tidy Help!
Basically you need to remove all the rear plastics, and then remove the current snow-shovel to fit the tail tidy. It's a reasonably easy job, but it can take a while. Give yourself an hour and a half to two hours and lots of tea break time and it'll be fine. It was the first thing I fit to the bike and it worked out fine.
|
Re: Tail Tidy Help!
So need to remove the whole tail plastics then? What kind of screws hold the plastics on?
|
Re: Tail Tidy Help!
Step by Step instructions . Have a look at this web site::rolleyes:
http://www.hamicad.co.uk/SV_Fender/S...ions%20new.pdf |
Re: Tail Tidy Help!
Quote:
HTH |
| All times are GMT. The time now is 10:21 AM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.