Stubbie'd my endcan.
 

Last weekemd I got a phone call from WRC63 who said "Do you remember what we talked about on Thursday ?"
"No" I replyed.
So apparentaly we said we would cut it down.

So saturday morn Dan (aka WRC63) came round to do some cutting.

Looks a bit too Long IMHO
http://img301.imageshack.us/img301/5251/stubbiedu5.jpg

can you spot the dent?
http://img341.imageshack.us/img341/1876/stubbie1bd2.jpg

No going back now
http://img301.imageshack.us/img301/1979/stubbie2ve1.jpg


Drilling for the new pop rivits.
http://img301.imageshack.us/img301/2299/stubbie4sf2.jpg

Thirsty work this... we chopped off 18.3 cm.
http://img301.imageshack.us/img301/8703/stubbie5az4.jpg


Finished result... very aesthetically pleasing to the eye...
http://img341.imageshack.us/img341/6...ubbie18sf0.jpg



Sounds sweet too....video...

Re: Stubbie'd my endcan.
 

oh yes,looks miles better and sounds sweet:thumbsup:

Re: Stubbie'd my endcan.
 

Nice work! Sounds like it'll give Pete'n'Lissa's a run for it's money!

Re: Stubbied my endcan...
 

Very Sweeeeet.

Looks so much better than that Longy. :)

Does it sound much louder?

Re: Stubbie'd my endcan.
 

Damnit!

Just as well it's fitted to pointy otherwise it might well win on looks! :smt043

Re: Stubbie'd my endcan.
 

NICE!! :smt077

Re: Stubbie'd my endcan.
 

I was just about to create a post asking how to do this. Is it just a case of cutting through the whole lot or should you take the end plate off then cut through each bit separately? Did you buy a new 'band' to rivet the end back on or make use of the old one?

Re: Stubbie'd my endcan.
 

getting the endcap back in was a nightmere...

Re: Stubbie'd my endcan.
 

Cheers Richie. Looks like I have a project for next weekend! :) Do you happen to know whether it will make it an MOT fail just by making it stubby?

Re: Stubbie'd my endcan.
 

Very sexy, Richie!




And the stubby isn't bad either!:D