Rim Tape - what should i know
 

Yes, i said rim, well done for noticing...;)


Now, after finding myself saying something i never thought i'd say in the LBS - "do you have any fluorescent yellow rim tape?" - i now have some, and was wondering what peoples' experiences were when applying? it's for the DRZ and i have a centre stand that gets both wheels off the ground and spinning freely, i don't really need to take the wheels off like the "instructions" say (that's about all they say)

anything else i should know, i have the one with the little plastic applicator so i assume i just get the tape settled then spin the wheel until it's completely round?

Re: Rim Tape - what should i know
 

check out this thread all of 5 days old.

Cheers Mark.

Re: Rim Tape - what should i know
 

i knew that thread was there, if you look closely i even replied... he was asking about colour choice and it descended into a rim-tape-haters convention;)

i was asking people who've applied it if there was anything they wish they'd known beforehand...

Re: Rim Tape - what should i know
 

Dont know what kind of tape your using but i find the easiest stuff is where it's already shaped to the wheel and is already cut into 4 quarters then you just do each bit seperatley until the wheel is finished.

Also make sure your rim is clean before applying(chuckle,chuckle,snigger);)

Re: Rim Tape - what should i know
 

Where can you get the Rim Tape in 4 quarters because i tried that stuff in the roll and it was ****e tbh.... would like to do mine but its difficult with out a paddock stand and if i try the stuff in quarters i might have a bit of joy.

Re: Rim Tape - what should i know
 

Thou shalt not spoil my fun...



... 'Rim'...

... tee hee hee.





Without a paddock stand it's going to be a tad more difficult - maybe just getting a mate over to hold the bike upright and move it forwards (or backwards depending on the way you are putting said tape on) a little each time you say the word.

My only other advice if you are going to go ahead and commit this sin of sins is take it very slowly and steadily, don't over stretch the tape and possibly even mark a guideline onto the wheel first. Use a Chinagraph pencil (get it from most art, craft or hobby supply shops) as these will leave a clear mark that can later be rubbed off - and they won't damage the surface.

See - I can do advice as well as childish humour...






... main point being - hit it with a hammer. ;)

Re: Rim Tape - what should i know
 

:p




should have said by centre stand i meant one of these:

http://img120.imageshack.us/img120/9733/dscn1148iv4.jpg

that holds both wheels off the ground

never got round to trying today, might have a go tomorrow:cool:

Re: Rim Tape - what should i know
 

You can find it here,there are a few various sorts to choose from . hth

http://cgi.ebay.co.uk/WHEEL-RIM-STIC...QQcmdZViewItem

Re: Rim Tape - what should i know
 

I've never fitted any myself- I like the look on the right bike, mine is not the right bike- but I noticed today at the show that even the sticker stall selling them had put the strips on squint on their display wheel :mrgreen: The sort that comes in a dispenser seem to be easier than the sort that comes on sheets.

Re: Rim Tape - what should i know
 

Get that dog on a diet :smt103