pillion rear ends
 

hey guys im new to this, and i was just wondering if the rear seats and tails from the later models will fit the earlier models, i think the later tail end is so much nicer and other than getting a single seat/race end its the only way i have seen to go about it, has anyone tried this or pulled it off before or even have some suggestions on the matter, or my girlfriend is going to have to start walking cos i really dont like the end as it is

Re: pillion rear ends
 

I stress I haven't actually done this, but I have seen it done, but you would need the subframe as well as they are different (K3 subframe is different to the later ones as well), so the riders seat would have to change as well.

Cheers Mark

Re: pillion rear ends
 

cool thank you, im guessing its not just as easy as unbolting one and bolting on the other either is it, i will find a way around this as i want a new ****, i cant find any nice pillion seats made for it and i thought this would be the easiest way
if anyone knows of sites that do the pillion seat as a kit that is better looking than the early standard rear end then please post an address for me
thank you
brad