SV650.org - SV650 & Gladius 650 Forum

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)
-   SV Talk, Tuning & Tweaking (http://forums.sv650.org/forumdisplay.php?f=111)
-   -   Gear Shift Lever removal (http://forums.sv650.org/showthread.php?t=133846)

gerbrox 14-06-09 03:21 PM

Gear Shift Lever removal
 
Hi all trying to replace the lever as above on a K3 pointy, basically got the plate off with the two hex screws, then used another hex screw to get lever assembly thingy off the plate, so I ve got the peg to remove from the arm, but I can't seem to budge it, tried hammering, spraying WD40 etc but only moved slightly, I think there's a lip / grove I need to get over, am I right?

Is there any other way or am I making things worse?

p.s. can't upload picture as yet, (file size problem)

http://i442.photobucket.com/albums/q...x/IMGP0359.jpg

eval k-neil 14-06-09 04:33 PM

Re: Gear Shift Lever removal
 
Hi gerbrox, I'm no mechanic but when I had to replace the gear lever on my K6 pointy it was just a case of removing a small circlip and sliding the lever off. Didn't have to remove any hex screws or anything??

hope that makes sense

neil

gerbrox 17-06-09 12:07 PM

Re: Gear Shift Lever removal
 
Thanks Eval, alas after a bit of preseverence I managed to get the bloody thing off, there was a sleeve / gasket inside that must have been getting caught, now in getting the bit off managed to kancker a couple of threads so it was touch and go before mr angry went off on one, all fine now, road tested and everything.

p.s. I think you were refering to the peg not the lever maybe the picture isn't so good after all.


All times are GMT. The time now is 03:20 PM.

Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.