Curvy belly-pan, How do I fit it?
 

Hey, Dudes and Dudettes!

I was given an aftermarket belly pan by the fella I bought me Curvy off. He didn't get to fit it as there are no brackets or bolts or bolt-holes either..

I'm wondering where to mount it and what to use. Any suggestions? I thought about them Ziplock cable ties, before anyone says that..(Joke)

It'd be nice to fit it as the front of the engine is a bit scabby..lol

Thanks in advance!!

Suskmeister...

Re: Curvy belly-pan, How do I fit it?
 

assuming they're all the same method of attachment then mine was:
1 long bolt through the hollow loop on the front (bottom) of the engine
Then 2 Z shaped brackets off of either side which were bolted to the belly pan and threaded through said long bolt.
Then there was also a 3rd bracket which was straight and attached the belly pan back to where the exhaust is bracketed on just behind the brake rear set.

Re: Curvy belly-pan, How do I fit it?
 

Thanks for the reply, it'll give me a clue at least!!

Re: Curvy belly-pan, How do I fit it?
 

Any idea what make it is or do you have a pic

Re: Curvy belly-pan, How do I fit it?
 

Err... It's red!! (He says, brightly.)

Not a notion mate... It's a fibreglass one, that's all I know! I'll take a photo and maybe someone will recognise it?

Thanks!

Re: Curvy belly-pan, How do I fit it?
 

^^^ A red one ha ha i spat my tea out then :D Pictures a good idea cos there are some clever peeps on here.