K3 Engine fix - Rotor removal
 

Ok, i will attempt to do this at some point this week so keep your eyes on this thread!

Thanks to all the advice so far about the right tools to use as progress through this, i though i would post a nice pick of the removal 'bolt' i picked up off ebay!

http://farm6.static.flickr.com/5255/...7dcaf0f0_z.jpg

Re: K3 Engine fix - Rotor removal
 

If it's the one from Boltmeup I used the same thing last week. I found it a wee bit long but it worked ok.

Re: K3 Engine fix - Rotor removal
 

Yup, got it from boltmeup! - they were selling em in pairs so i have 2!

Re: K3 Engine fix - Rotor removal
 

I take it the rotor holding bolt is threaded 'normally' and is taken off anti clockwise ?

Re: K3 Engine fix - Rotor removal
 

Yes, left loosey.

Re: K3 Engine fix - Rotor removal
 

Yes normal thread. Opposite end of crank (primary drive gear end) is a LH thread.

Re: K3 Engine fix - Rotor removal
 

I suppose both bolts at either side have to unscrew in the same direction (if you know what i mean!)

ta for the advice!

Re: K3 Engine fix - Rotor removal
 

Sorted pic shows final result and tools used to remove it!

http://farm6.static.flickr.com/5252/...8c333222_z.jpg

Once again, thanks for the advice so far!