SV650.org - SV650 & Gladius 650 Forum - Fitting Yoshimura tri oval on Pointy

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)

- SV Talk, Tuning & Tweaking (http://forums.sv650.org/forumdisplay.php?f=111)

- - Fitting Yoshimura tri oval on Pointy - where to cut? (http://forums.sv650.org/showthread.php?t=177370)

jaspa910

13-04-12 07:00 PM

Fitting Yoshimura tri oval on Pointy - where to cut?

Hi just purchased a mint yoshi tri oval end can off the bay but it has no measurments where to cut it can anyone help its a L1 11 plate cheers guys :p

Joe Marcon

14-04-12 01:07 AM

Re: Fitting Yoshimura tri oval on Pointy - where to cut?

40mm from weld point . Some1 verify me tho .

http://forums.sv650.org/showthread.php?t=87691

rictus01

14-04-12 01:30 AM

Re: Fitting Yoshimura tri oval on Pointy - where to cut?

55-60mm from weld if you want to avoid chopping into the cat.

Cheers Mark.

jaspa910

14-04-12 02:03 PM

Re: Fitting Yoshimura tri oval on Pointy - where to cut?

i take it its a standard for most than ,i'm going to fit it tomorrow and hope it all goes well ,cheers for the reply's
Lee

All times are GMT. The time now is 01:02 PM.