Removing damper rod bolt - how?
 

Im striping the front forks to replace seals and give them a general check but im struggling to undo the alen bolts to release the damper rods is there a knack or is it a trip to the local bike shop ? its a 2000 s standard trim cheers Glen

Re: front forks
 

Shove a broom handle up to stop them spinning

Re: front forks
 

Or if that doesn't work, a powered (air or electric) impact driver

Re: front forks
 

Theres a way you can keep the fitted & use the axle rod to stop them from spinning to crack it. It's on my thread for overhauling them.

Re: front forks
 

+1 for broom handle, or re install internals an put the tops back on...

Re: front forks
 

The broom handle technique didn't work for me. I got a 12v impact wrench off eBay and it worked effortlessly. It has a lighter socket attachment too so it's in the car incase I get a flat. Not bad for £20 ish quid

Re: Removing damper rod bolt - how?
 

Thanks chaps will give it a go

Re: Removing damper rod bolt - how?
 

The only thing I dont think anyone has mentioned about the broom handle is to chamfer the end a little so it wedges in. But eaiser to use an impact driver or drill with hammer action I found worked.

Re: Removing damper rod bolt - how?
 

cheers guys all sorted , well happy and ready to go

And to think how much you saved if you had a garage do it!