R&G crash bung for faired pointy
 

Hello, got the full fairing kit and r&g crash bung kit...it's had an off on one side though so just need a single crash bung. If anyone has one, let me know

Re: R&G crash bung for faired pointy
 

Direct from R&G will be your best bet.

Re: R&G crash bung for faired pointy
 

Yeah did a bit of research and it seems it's about £20 for a single one. Might even send a pic of the busted one as apparently they bum that and will send you a free one out haha!

Re: R&G crash bung for faired pointy
 

One of mine fell off and I was quoted £12 posted though that was a few years ago. Sending them a pic sounds like a good idea if there's a chance of a freebie!

Re: R&G crash bung for faired pointy
 

Freebies make me happy, thanks for the info :)

Re: R&G crash bung for faired pointy
 

I tried the freebie option to no avail. The amount of ass kissing they must get nowadays for freebies though...

I have a bung and screw from a curvy. I think it should be the same screw size as the bracket/holder are the only differences. If you send me a photo of your attachment bracket i can see if it'll likely fit and post it over for a good price. It's only been knocking around my garage.

Re: R&G crash bung for faired pointy
 

for a fully faired curvy? Will get some photos soon, I reboxed it all and it's a pain to get into haha

Re: R&G crash bung for faired pointy
 

There should be a plate that is screwed in at either end on the frame in two points. Then in the centre point there is a thread where the bung goes. Should just be the screw and bung that needs replacing?

Re: R&G crash bung for faired pointy
 

I am almost sure the bugs will be different sizes. I know the fully faired pointy bung is shorter than the half failed pointy bung.

Re: R&G crash bung for faired pointy
 

As above, half the length more or less!