![]() |
Jerking
Hello all jus wondered if anyone had any ideas on what this problem is Just had the clutch plates fitted she run beautiful for a while full response on the throttle was like a diffrent bike few small more problems poking up now .. she's a k1 by the way so she's old .. from cold she idles rough even when she's running I've had the carbs cleaned I'm thinking the choke plungers or somethings stuck somewhere she climbs slightly on idle goes from 2000 to 3 then back down then back up almost like an invisible hand is cracking the throttle.. Also just now ran into work with her and she's just started jerking a bit and losing power then coming back on I think it's spark but would like a few opinions maybe a new set of carbs is the way forward. TIA
|
Re: Jerking
For starters check that the seals inside the Airbox have not been malformed and are a secure fit to the Air intakes underneath the Air-filter.
|
Re: Jerking
And the two crankcase breather tubes are properly fitted to the airbox. In fact check for air leaks on all the tubing. Then service the choke plungers. Then check the throttle cables for correct free play as they would have been disturbed when the carbs were cleaned. Water in the front plug recess? Lots to do before drastic stuff like new carbs.
|
Re: Jerking
Thanks alot guys I'm.not very mechanically minded but I'll get someone to have a look cheers
|
Re: Jerking
Actually onkybstarted jerking after it rained and I no my bike hates the rain more than likely the front cylinder thanks alot.
|
Re: Jerking
Sorry too sound stupid what's the best method to check for air leaks on all the hosing.
|
Re: Jerking
Quote:
|
Re: Jerking
Quote:
https://www.amazon.co.uk/s?k=silicon...sl_7o364ijr8_b |
Re: Jerking
Quote:
|
Re: Jerking
Well after everyone's reply I've decided to order the silicone grease you've shown me and bought a fender extender from rng thanks for all your replys it's appreciated.
|
All times are GMT. The time now is 05:13 PM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.