SV650.org - SV650 & Gladius 650 Forum - 2009 SV won't prime and have CHEC light?

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)

- Bikes - Talk & Issues (http://forums.sv650.org/forumdisplay.php?f=129)

- - 2009 SV won't prime and have CHEC light? (http://forums.sv650.org/showthread.php?t=235147)

2009 SV won't prime and have CHEC light?

I was adjusting the clutch at the front sprocket the other day and when I was piecing everything back together, it would no longer start. I'm unsure if I knocked anything etc.

When I turn on the ignition, the dash lights up as usual, the tachometer's needle doesn't move (unless I disconnect the battery and reconnect it, which it then goes to 7k rpm and back to 0 only the once). The fuel pump doesn't prime. After about 3 seconds I get a CHEC light. I haven't accidentally forgot about the kill switch, the sidestand switch i'm sure is fine as is the clutch switch.

If I try and start it while pulling in the clutch, nothing happens (no cranking). Just my headlights go dim/off. When I tested the voltage from the battery terminals, I got an extra 0.10V as I pressed in the starter button.

I have tested the clutch switch itself for continuity and that was fine. I also tested the killswitch which was fine. I tested the sidestand switch and didn't get a beep, but I got some numbers on the multimeter which I assume is the resistance of the circuit (as i tested it from the male plug that normally plugs into the female end under the tank).

I have tested all fuses and they're fine. I have also tried a battery out of an R6 to no avail.

I also can't seem to get into the dealer mode when bridging the 2 pins, I just have CHEC displayed.

Re: 2009 SV won't prime and have CHEC light?

OK just read that properly, so not an accidental on kill switch. What about the starter relay? However I hate electrics, and ain't that good with them, hopefully someone with more knowledge will be along shortly. Good luck.

Re: 2009 SV won't prime and have CHEC light?

Quote:

Originally Posted by shiftin_gear98 (Post 3110824)

Ahaha no worries. I don’t know how to check it? And I’m somewhat the same. I just don’t have the knowledge about it.

Re: 2009 SV won't prime and have CHEC light?

SO! All fixed. Turns out this bike has an alarm/immobiliser that I was not aware of.

Re: 2009 SV won't prime and have CHEC light?

according to the manual (admittedly not the one for your bike) it can only be the kill switch, ignition fuse or a connection between ECU and speedo unit that brings up CHEC. This will not bring up any fault codes...