![]() |
Puncture bother
I was on my way home on the GSX when I realised something was amiss. I thought I had a front tyre puncture but it was actually in the rear tyre. I couldn't see anything obvious so I used my CO2 cartridges (from repair kit) to add some air. I got home although tyre pressure was barely registering by then. I found the puncture after pumping it back up (with a foot pump - my legs ache!) and hearing it whistle when under the hugger.
I decided to have new tyres fitted but dealer didn't pick up the phone so I went back out to investigate wheel removal only to discover you need a 19mm hex bit to remove the front axle which, of course, I don't own. Ordered one. I then thought I have nothing to lose by trying to patch it with sticky string, unfortunately my rubber cement had set so I did it without (I checked and the cement is primarily there to act as a lubricant). It was hard work without that! I've pumped the tyre to a higher pressure than normal and will check it in an hour or so. I'll probably still get new tyres although I have run other bikes for several thousand miles on a sticky string patch before, equally I've had one fail almost immediately, so there is a bit of a gamble. |
Re: Puncture bother
I've used sticky string repairs on a few occasions Seeker, and it's always proved pretty reliable. I've run a couple of tyres with the stuff in for several thousand miles in the past with no problems.
|
Re: Puncture bother
Bought one of these like this a while back. Makes keeping tyres pumped up actually enjoyable that along with 90 Deg Tyre valves :)
https://shorturl.at/FWYAI https://i.imgur.com/7aLKqHS.jpg https://i.imgur.com/XPGfXx9.jpg I run ,"Slime/Goop" in my tyres and have done for around 20 years. I've only had a couple of slow punctures in all that time :) |
All times are GMT. The time now is 09:05 PM. |
Powered by vBulletin® - Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.