License Plate Holder
 

Hello

I want to remove my current license plate holder, it's too big and ugly.

Here's a picture of it:
http://img133.echo.cx/img133/1127/svrear2og.png



How can I make it look like this:
http://www.sv650.org/pic7/1.jpg
http://www.sv650.org/pic8/SV_Renegade_4.jpg

I bet some of you have done this. Could you guys help me out?



Cheers!

simple, purchase a 'tail tidy' kit and fit it :)

Or an undertray... :wink:

Or if you/partner/parent is any good with a bit of hardware, use the pattern on here and make your own. I did mine last weekend but i've been off work so couldn't get pictures on here :roll: . It took me about half a day to make it up, fit it, take it off and paint it then refit it all. My bike now has a very petite rear end as opposed to the monstrosity that was :shock:
I'll get back to you with pictures 2moro but the link for pattern and explanation is Here www.sv650.tk It's under the mods section. I modified the design slightly so that the ECU sits in it's normal place, and made a hanger myself instead of buying the motrax one. Even used original indicators but they somehow look smaller.

http://www.thebikereview.com/iup/get8.asp?ID=583
From The side
http://www.thebikereview.com/iup/get8.asp?ID=584
From the Back
http://www.thebikereview.com/iup/get8.asp?ID=585
And as you can see the ECU goes back in the original place so no chopping/relocating wires. I've also tinted rear light and indicators with tinting spray from halfords. Finishes the job nicely i think :lol:

See my thread similar to this?

http://forums.sv650.org/viewtopic.php?t=24334

Good luck!