Problems starting
 

sometimes, when i go to start the bike, nothing happens. i know exactly what it is, its the two cable connectors on the clutch. does anybody else get this problem, and is there any way of sorting it??? its slightly loose, so is there a way of tightening it up??

You can bypass the whole switch and remove the switch assembly... IMO not at all unsafe unless you're a spanner, and gives you a lighter clutch action as well as a nice one-handed start.

how do you bypass the switch then??

I had the same problem on mine.

Just cut the 2 wires going to the switch by the clutch lever and soldered them together, then wrap in electrical tape.

Easy peasy. :D

Proper self-amalgamating tape would be better for permanence mind.