Does any body know....?
 

The dimesions for the suspension link plates that raise the rear of the bike by approx 1". The bike they are for is an SV650s (1999) curvy.

Thanks in advance :thumbsup:

the hole centre`s for 1" of lift should be about 101 mm

a standard one is 105 mm

not sure of the hole size its 12mm i think

so a couple of plates that are 5mm thick by 130 long with radius edges not like my rough drawing should do you

http://uk.geocities.com/gazdulux@bto....com/links.JPG

edited the drawing Capt'n Nemo sent me.
but you get the idea
http://www.thebikereview.com/iup/get8.asp?ID=1207

I prefer Barty's drawing :D

me too, much more sophisticated, richies looks like somthing a kiddie drew on mspaint!! lol :lol:

TRICK

Does anybody know the dimensions if i want to
do the same operation on a pointy (k4)

Thanks in advance :wink:

.