What size is the banjo for the rear master cylinder?
 

It's M10 x ???. This is at least the 10th time I've asked this :)

I know but I'm not telling you...

OK then :roll:

i'll narrow it down to two. Either 1 or 1.25 pitch. :lol:

Might be an idea to get one of each? The (standard caliper) fronts use 10x1.25 and yet has 10x1 at the m/c. Bleedin' Suzook brakes eh!

As a hunch, I'd say 1mm on the rear, I think it was the opposite to the front.

You are- as ever- a faunt of kowledge Haggis ;) I'm getting a pressure switch for rearsets so they're a bit pricey, I'd sooner not buy both. I know the SV uses both sizes but I can't remember which is which :roll:

The master cylinder and caliper seem to use the same pitch though, if that's any use.

Well if it's not mega urgent I can find out early next week for you - if all goes to plan. I'm getting new lines made up this week, should be here by Monday.

Ach, no need for that, I can find out from 2WJ if it comes to that... Just put off the buy for a day. Cheers though!

Just bought some VALTERMOTO rear sets from HG £134.99 look the dogs nads I'll post some pics tomorrow if you want!!!

The pressure switch I got was a fine thread the same as the brembo one!!

I'm getting Woodcrafts 8) They are things of simple beauty.