Fitting front mini indicators
 

I bought some mini arrow indicators a while back with the intention of fitting them but never got around to it.

Before I take the fairing all off, I need to know, do you require spacers as I've seen on other bikes?

Quick reply appreciated might do it today while I'm feelin a bit worse for wear...

Come on peeps one of you must know..

I made wee panels to cover over the holes from the inside, cut it to size then fitted it using the standard indicator fitting ring and scrwes. Then drilled a hole in those. Any flexible plastic would do, I used Sony minidisk cases ;) Loads fo ways yuo could do it, but you will have to do something.

For a pointy? Yes I think so.

Top tip, seal the wires in the bolt or they will let in water and rust like mine have. :(

is it a pointy??.

on my curvy I didnt take the panels off- u can reach in.

and just used indy spacers.. one at the front and one at the rear of the hole- they fit flush..

Jake, isnt your bike making horrible grinding noises??? Id get that sorted before putting on mini indicators ;)

Same as northy. Made some plastic plates for inside and mount the indicators to that.

viney yours is a curvy aint it??


the indy spacers- set of four fit perfect !... one is hollowed out and one is plain flat.......

So is jakes

I have no stalks showing on my bike as they are short stemmed, and fitted at the inside :D

Yeah, I made covers same as northwind, didn't require an spacers and mine look like this:

http://img442.imageshack.us/img442/5...theadon8bb.jpg

well for a fiver i would just get the indy spacers... the coffin type ones..