front wheel removal tool?
 

what size is the allen key needed to remove the spindle from the front wheel? as i need to get the wheel off to replace the tyres

cheers will

Dont know on the Sv the GSXR is 24mm, but motrax, available from most places, do a fromt axle key (3 sizes on one), I think there about a tenner. The cheaper option would be yo get a couple of inches of the the right size hex bar and put a socket on the end.

Re: front wheel removal
 

12mm on my K3 - doubt it has changed on the K6 :D

Re: front wheel removal
 

Ok return of the stupid question :rolleyes: where's the cheapest place to get one ????

Plus any tips for wheel removal would b welcomed

Thanks all:cool:

Re: front wheel removal
 

I'd buy a set of 5/8" allen sockets, as the spindle will need to be torqued up when replaced. You can get these from Hellfrauds etc.

Re: front wheel removal
 

Cheers :) any tips or pointers anyone for front or rear wheel removal?
as this will b my 1st attempt :( (oh k9 sv650sport b4 u ask)
Many thanks again for all your help & knowledge :)
Tom

Re: front wheel removal
 

front and rear paddock stands are a good start, and once the big bar is unscrewed just pull it through while taking the weight of the wheel. But bare in mind there is a spacer on one side and a cable and speedo drive housing on the other. Make sure the drive housing is clear before pulling the wheel to remove. As the speedo drives on sv's are made from cheese and can break very easily

Re: front wheel removal tool?
 

12mm = FIAT sump plug key. Available from most motor factors for not-a-lot...

Re: front wheel removal tool?
 

failing that one 12mm bolt and two 12mm nuts. lock one nut against the other on the bolt and then place the bolt in the socket and use a spanner on the inside nut.

Re: front wheel removal
 

- Don't be alarmed if the rear wheel "alignment" marker things distorts and bends round the swing arm ..... :smt013 TOFFEE!

- Counter hold all nuts where you can
- Don't be afraid to use force - it's a fairly hefty amount of pressure to make it move
- Hex (6 sided) vs Bi-Hex (12 sided) ... makes no difference - each can slip off :rolleyes: Hex will give you slightly more grip.

Give it a go and let us know!

If you want a good video for removing the rear wheel (also for chain adjustment) check out CanyonChasers video on youtube for their curvy

http://www.youtube.com/watch?v=zB4DsHV8SAQ

Cheers

Al.