SV650.org - SV650 & Gladius 650 Forum - Torque settings for clutch cover bolts?

SV650.org - SV650 & Gladius 650 Forum (http://forums.sv650.org/index.php)

- SV Talk, Tuning & Tweaking (http://forums.sv650.org/forumdisplay.php?f=111)

- - Torque settings for clutch cover bolts? (http://forums.sv650.org/showthread.php?t=75832)

northwind

06-08-06 10:23 PM

Torque settings for clutch cover bolts?

According to the workshop manual, the clutch cover (inner and outer) and water pump cover bolts are all 10nm... Don't have my Haynes manual to hand but I thought it specified a waaaaaay higher torque? If anyone could check it out that'd be grand, I'm a little suspicious.

svrash

06-08-06 10:27 PM

yep :wink:

TSM	06-08-06 10:27 PM

I thought it was 5nm

21QUEST

06-08-06 10:37 PM

Quote:

Originally Posted by svrash

yep :wink:

correct

northwind

07-08-06 12:36 AM

Nice one. If it leaks now, it's your fault ;)

Viney

07-08-06 07:46 AM

The correct setting is, tighten until it strips its thread, then back 1/4 turn.

HTH

BILLY

07-08-06 07:56 AM

Quote:

Originally Posted by Viney

The correct setting is, tighten until it strips its thread, then back 1/4 turn.

HTH

Or snaps of in the casing :lol:

northwind

07-08-06 09:40 AM

Quote:

Originally Posted by Viney

The correct setting is, tighten until it strips its thread, then back 1/4 turn

That's what I usually do, but my Probolts Super-tat anodised bolts shear off before that :)

svrash

07-08-06 06:09 PM

All the OEM ones i've ever taken out all have warped :?

All times are GMT. The time now is 07:10 AM.