pointy under tail template?
 

I was wondering if anyone has made their own under tail. I was looking at my bike and I dont think it would be too hard to make one. I'm kind of tight on cash and I'm tired of the snow shovel look. If anyone has a template for a pointy they could post up it would be a big help.

There is a good template and instructions in the "FAQ and How To" section on the site main page. This is how it comes out.


http://upload4.postimage.org/987531/rsend1.jpg


http://upload4.postimage.org/987535/rsend3.jpg

I had a go at this project, make sure that the sheet of metal you use isn't too flimsy, mine was. I am waiting for my bro to get me a thicker piece laser cut before I try again.

Ste

i did that one but couldnt get it to quite fit right so slung it and got an R&G one.

That looks really good. I'm going to try it. any one got any advice on cutting off the fender? thanks a lot.

you unbolt it off not cut it off.

oops, I unbolted it then cut the fender, then I put the insert back on so that there wouldnt be so much of a gap. It still works. I'm almost done with this project. all I have to do now is get some hardware to mount it all together. I should be done tomorrow.

post us some pictures when your done :D

i finished it yesterday. its been raining so i'll post pics as soon as i can.

this is my final product. the metal is kind of thin but it does the job.

http://i12.photobucket.com/albums/a2...undertail2.jpg
http://i12.photobucket.com/albums/a2.../undertail.jpg
http://i12.photobucket.com/albums/a2...ication002.jpg