PC problem - dead I guess ?
 

Hi

just bought a D-Link Range Extender (DWL-G710) to boost my wireless signal

Instructions say plug it in, connect ethernet cable and go to http://192.168.0.30 and then logon and change settings etc.

Except that it doesn't respond :cry:

Tried pinging it as well, but still no response

Also tried resetting it (no joy) and checking the manufacturers help page to see if the IP address had changed (nope still the same). Also tried a different cable as well

So I guess it's dead and needs sending back, unless anyone else has any ideas . . .

cheers

Sounds dead to me.

You might want to try setting your pc to a static IP address 192.168.0.XX (where X is anything, aside from 30 ;) )& try that -like byeager says here:

http://www.expansys.com/ft.aspx?i=125366&thread=1

Worth a go anyway before u send it back

Jonathan

Yep try setting it on the same subnet.

If you have a dhcp server somewhere, then it may of assigned the unit an address. They are clever like that. Except they wont tell you what address they gave it!


Dan

connect your PC to the device & to nothing else

set your PC to dhcp, I'll bet that the device has a dhcp server in it & will assign you a 192.168.x.y/z address, then browse to http://192.168.0.30

I'd go for that too. Often, a private network is going to be running IP addresses in the range 192.168.1.??. If so, 192.168.0.30 is 'off-site' and is only reachable via your gateway/router (unless you frig with the subnet mask - don't ask me). My office WIN2K server's DHCP service allocates addresses in the 192.168.1.* range.

maybe your firewall is blocking access to 192.168.0.30

If you read this quick install guide here it tells you to set up a static IP address/subnet, see section "before you begin":
http://www.dlink.com/products/suppor...kInstallGuides


8)

:notworthy:

I love you guys :D

If it were possible for me to have your babies I'd be first in the queue :wink:

Let's hope it makes a difference to the reception at the top of the house

cheers