Why doesn't my seat cowl fit lower?
 

Ok why is it like this?

I have read u can swop over the fittings from the back seat.. but mine on the cowl(cowel??) are riveted on?


is this the normal height?



http://i22.photobucket.com/albums/b3...mpleted015.jpg


I ask cos I am going to make saddle shutters and if I can get it lower all the better B4 I make the shutters.

Re: why doesn tmy seat cowl fit lower
 

I dunno if its same on curveys but when i fitted my undertray on my pointy the seat cowl went the same on mine.. I swaped the rubbers from my seat to seat cowl and it worked..now sits same level,,again!!! HTH..

Rich

Re: why doesn tmy seat cowl fit lower
 

That looks a little higher than normal, although the gap does need to be reasonably generous at the back. You have to be able to lift the front high enough to clear the locking mechanism before you slide it forward and the back tilts down as you do. Try gluing an extra strip of rubber on the rear locating tab to pull it down a bit. Double sided sticky tape would be good whilst experimenting to find the required thickness. the gap at the front looks normal to me.

Re: why doesn tmy seat cowl fit lower
 

cool

apprecaiated..
now I wanna go out and do it NOW.!

Re: why doesn tmy seat cowl fit lower
 

that doesnt look fitted right. mine does that when I have miss located the bit that slides under the metal bit first.

If it misses that it still clicks down but sitting on the wiring and high.

Re: why doesn tmy seat cowl fit lower
 

I skimmed some of the rubber off the mountings on mine, that helped...

Re: why doesn tmy seat cowl fit lower
 

I will try it all !!

ta muchly

Re: why doesn tmy seat cowl fit lower
 

its a lot lower now guys thanks..

still not flush but its better

dam I like this site.

Re: why doesn tmy seat cowl fit lower
 

eot did u do..................picy

Re: why doesn tmy seat cowl fit lower
 

theres a pic in my saddle shutters bit.. ..


I just put some rubber and gaffer tape around the top of the hook it hooks under .. under the seat.
and its a tighter fit..
not brill but tighter.