fitting scotoiler injector to pointy
 

Hi have got a guide to fit ( thanks Cloggsy) , however this shows a dual injector
I'm going to fit a std single injector .

any one got a photo on how you can fit using paddock bobbin hole ?
Do you get needed bits in kit to fit to bobbin hole thingy !
Want to route tubing so that I can use my standard paddock stand
Don't want the injector to move !!

found this on the scotoiler site showing the rear axle bolt being used which looked good as tubing could be rooted ontop of swing arm

see 4th pict down on link http://www.scottoiler.com/support_guide3.asp

Cheers Steve

Re: fitting scotoiler injector to point
 

mines like the 1 in the piccy, you do get all the bits needed when you buy 1 unless you get a 2nd hand one like i did

Re: fitting scotoiler injector to point
 

Thanks Hovis

How the f##k did you loose 8 stones , I lost 3 stone once and that was hard work !

Well done that man

Cheers Steve

Re: fitting scotoiler injector to point
 

is the universal kit the one you need for the sv?

Re: fitting scotoiler injector to point
 

On the scottoiler site if you download the fitting instructions for a pointy SV it has a picture of an SV1000 swingarm with the dispenser attached to the swing arm bobbin.
Basically you need to have swingarm protectors fitted, then you place the scottoiler bracket behind the protector.
http://www.scottoiler.com/userfiles/...%20SV1000S.pdf