i have a problem...
 

after fitting my tail tidy (bought from redbeeproducts off ebay-dont go there)

im now left with this.....

http://img170.imageshack.us/img170/6436/dsc00581cw5.jpg

one great big gap... godd innit? :(

any suggestions on what i could do? or praps an undertray that would fit and needs no cutting?

quick. i feel like crying!:smt022

Re: i have a problem...
 

This is the reason why i didn't get a tail tidy and went for the undertray. Why the hell do they make them with the gaps? Surely its just as easy to make them properly than not :smt102.. If your only worried about water getting in there you could always use clear silicon to fill the gap!! Apart from that, i suppose you could coverer from the inside with some black plastic or something glued/taped in place!!

Wonder what others have done, is there actually one they make that fits properly??

Re: i have a problem...
 

I can't see any gap in the picture, but you could use a roll of draught excluder if the gap is not too big.

Re: i have a problem...
 

im not too sure whats wrong?

is it that the plate is lower than you wanted?

get a new plate & drill it lower down .perhaps

Re: i have a problem...
 

I hope this helps you all out,, sorry stoppy jumping in :roll:

http://i168.photobucket.com/albums/u...00581cw5-1.jpg

Re: i have a problem...
 

cant see the gap....

because the shovel has been removed, the undertay has nothing to fit into. leaving a gap revealing the screws that attatch the tailtidy to the framework underneath.

was thinking of gaffa taping it up till i can think of something to do to it

Re: i have a problem...
 

nothing to do with the number plate. im going to get a smaller one eventually to raise it up between the indy ut the gap is still there

Re: i have a problem...
 

sorry, i still cant see the problem

Re: i have a problem...
 

Re: i have a problem...
 

can u not get an undertray and then fit the tail tidy to it or dont you wish to do that?