SV650.org - SV650 & Gladius 650 Forum - View Single Post

23-01-07, 05:32 AM

Hi all,
Sorry about this, yes I know this subject has been raised on here quite a few times but I'd like to claify it all.
Looking to fit the GXSR front end mod and the 636 rear shock mod. Ive set myself a buget and hopefully ill stick to it.
Ive looked through past posts on here and used a bit of common to try and figure out all the componets ill need. Looks pretty expen... i mean extensive but here we go.

Yokes
Axle
Fork Legs (Radial/USD)
Radial Calipers
Clip Ons
Mud Guard
Wheel
Wavey Discs
New Pads
Braided Hoses
Speedo Converter (Where from?)
Master Cylinder

636 Rear Shock

I do have a couple of questions though. Do I need all new switch gear or can some be retained from my K4S? Do I need specific yokes for ignition barrell etc? And which wheels/yokes/forks are best combination? Compatabilty etc... Also is there anything extra needed for the 636 rear shock mod, baring in mind shorter dog bones have already been fitted.
Many thanks all and any advice will be much apreciated.

23-01-07, 05:32 AM	#1
Sideshow#36 Guest Posts: n/a	GSXR Front/ 636 Rear (Again!) Hi all, Sorry about this, yes I know this subject has been raised on here quite a few times but I'd like to claify it all. Looking to fit the GXSR front end mod and the 636 rear shock mod. Ive set myself a buget and hopefully ill stick to it. Ive looked through past posts on here and used a bit of common to try and figure out all the componets ill need. Looks pretty expen... i mean extensive but here we go. Yokes Axle Fork Legs (Radial/USD) Radial Calipers Clip Ons Mud Guard Wheel Wavey Discs New Pads Braided Hoses Speedo Converter (Where from?) Master Cylinder 636 Rear Shock I do have a couple of questions though. Do I need all new switch gear or can some be retained from my K4S? Do I need specific yokes for ignition barrell etc? And which wheels/yokes/forks are best combination? Compatabilty etc... Also is there anything extra needed for the 636 rear shock mod, baring in mind shorter dog bones have already been fitted. Many thanks all and any advice will be much apreciated.