The stand is no problem as I've managed to design and contruct something similar to what you've got. Not as nice but practical and solid. I've done loads on bikes but as yet have never tackled this bearing thing yet. Always a first time I suppose. When you say that I'll need long pin punches do you think I could use thick wooden hardwood rods so as to minimise damage? Northwind, a friend from this here forum has suggested that I should freeze the components prior to removing/installing since the metal contracts somewhat and makes fitment or removal easier. I have a can of freeze which I use on electronic components at work which should do the trick nicely. The new bearings I'll put in the freezer prior installation. Any idea what type of greese best suits the bearings. Graphite greese comes to mind. Any suggestions?
I've scanned the net on he subject of replacing the stock roller bearings with tapered ones. The guys who work in bike shops suggest to fully tighten things with roller bearings and then going back half a turn. Thought I'd put as much info on the subject here in case there's some other guy who'd be doing this mod in the future.
Also found cheaper bearings on ebay:
http://cgi.ebay.co.uk/Suzuki-SV650-S...QQcmdZViewItem