51 plate curvy suspension change
hey everyone i have been reading loads on what suspension to upgrade to on the sv and i have a complete setup off a k1 gsxr600, and i am going to swap the rear end completly, the swingarm is the same dimensions as the sv but i am not sure about the swingarm spindle, and i want to change the front for the gsxr forks, brakes and wheel.
however the headstock shaft seems to be a bigger diameter and i dont know if the sv headstock bearings will fit.
so my question to you all
will the sv swingarm spindle interchange with the gsxr600 k1 spindle?
will the 51 plate sv650s headstock bearings interchange with the gsxr ones?
once i have fitted the gsxr forks etc i need raised clipons so the bars wont scrape the fairing, i have seen that the tl1000 ones with the usd forks but no mention of what fits the smaller gsxr600 ones?
cheers
|