Quote:
Originally Posted by yorkie_chris
It's a pain in the rse. Just grease everything properly and it'll be right for months.
Spray grease in the cable splitter, normal grease in the choke lever, copper slip on the screws. PTFE spray/GT85 on linkages and stuff.
|
Cheers again! Not to mention a damn good buffing up before I bung it all together- and smear copper slip on the outside of the plate/screw.
So- would a quick spray of Wurth Dry Chain lube do the trick where the cable links into the plungers? (just on the cable end, mind)- this appears to be outside the fuel/air flow.
Quick question on removing the carbs- am I better removing the throttle cable from the handle bar? It looks less likely to upset the balance of the cable than removing the cable from the carb assembly.