SV650.org - SV650 & Gladius 650 Forum - View Single Post

22-01-09, 10:57 AM

It's gotten to the stage where i badly need to rejet my stock set up carbs.

Currently on my 01 i have a K and N air filter, and a CCC can, the results of which are a huge flat spot at 4K rpm in second gear, and general lumpiness down low, and between gears.

What i aim to do is, Remove the carbs and clean them, following this thread http://forum.svrider.com/showthread.php?t=85513
Once thats completed, i'll fit Tank spacers and remove the foam from under the tank, and rejet.

I have been half thinking about fitting a BMC RS filter also, but cash is a bit tight and will have to wait

My main questions would be as follows.

Based on the set up described, ( CCC can, K and N filter, tank spacers and removed foam ) who wants to guess the jet sizes i should aim for ? cash is a bit low, remember we are in a recession over here also in Ireland.

What about cleaning my carbs, would ethinol be usefull in this process or would i be better off take then some where and get them blashted ( not the technical term of course)

22-01-09, 10:57 AM	#1
drag Guest Posts: n/a	Rejetting and Rebuilding carbs . help It's gotten to the stage where i badly need to rejet my stock set up carbs. Currently on my 01 i have a K and N air filter, and a CCC can, the results of which are a huge flat spot at 4K rpm in second gear, and general lumpiness down low, and between gears. What i aim to do is, Remove the carbs and clean them, following this thread http://forum.svrider.com/showthread.php?t=85513 Once thats completed, i'll fit Tank spacers and remove the foam from under the tank, and rejet. I have been half thinking about fitting a BMC RS filter also, but cash is a bit tight and will have to wait My main questions would be as follows. Based on the set up described, ( CCC can, K and N filter, tank spacers and removed foam ) who wants to guess the jet sizes i should aim for ? cash is a bit low, remember we are in a recession over here also in Ireland. What about cleaning my carbs, would ethinol be usefull in this process or would i be better off take then some where and get them blashted ( not the technical term of course)