SV650.org - SV650 & Gladius 650 Forum - View Single Post

27-01-09, 01:49 PM

I All,

I'm trying to get my forks apart to get the lowers powder-coated.

I can't get the 8mm Allen head out of the bottom of the forks. I have the impact driver and hammer, but no "straight" allen key. It need to be about 70mm long.

Do any of you helpful and generous lot have one I could borrow to get my forks apart?

27-01-09, 01:49 PM	#1
sam anon Guest Posts: n/a	8mm Hex head "spline" to borrow? I All, I'm trying to get my forks apart to get the lowers powder-coated. I can't get the 8mm Allen head out of the bottom of the forks. I have the impact driver and hammer, but no "straight" allen key. It need to be about 70mm long. Do any of you helpful and generous lot have one I could borrow to get my forks apart?