Quote:
Originally Posted by yorkie_chris
See if it will polish out, some autosol or brasso or something does the trick.
Make sure you clean all polish off with brake cleaner after.
Use rubber grease, put some in the seal grooves, install seal, press down on seals and wipe off excess. Smear a little round the pistons and install.
|
Cheers, I'm not sure you can tell from the photo but they are marks from pliers ...not sure they'll polish out. Guess I can make them as safe as possible though with a bit of fine henry cloth.
My floating disks travel a few mil too is that normal? I jacked it up and because the brakes were dragging when I moved the wheel side to side it made a right clunk.
Ta chris.