21-06-09, 02:20 PM
|
#16
|
|
The Sick Man
Mega Poster
Join Date: Nov 2004
Location: Peckham.SE.LDN
Posts: 4,768
|
Re: Has anyone else had problems with Delkevic can hitting the swingarm?
Quote:
Originally Posted by Mr Farley
I looked at where I trimmed the pipe (50mm from weld), and decided it wouldn't make any difference to trim more off (it could only be another 5mm max anyway).
|
Even 1mm will make a diffrence, a fe mm less at the bottom will angle it out by a 1cm or so.
if the whole can is too close then its usualy to do with the hanger or the strap not being bent correctly
__________________
OTR: KTM 690 Duke R 2015 Full Akro
SIDELINE: Kwak ZX636 A1P 2002, Red, R&G's, Yoshi, Double Bubble Screen
GONE: Kwak ZX-7R P1, Full Akro, Undertray, Screen
GONE: SV650S K2 Very Bruised & Without Fairing, Motovation Frame Sliders, R&G Ally Sprocket Toe Protector, HEL 2 Line Setup, GSXR K1 600 RWU Forks, Barnett Clutch & Springs, Penske 8981 Shock, Gilles Ti Rearsets, Steel Barends, Scottoiler, AFAM Chain & Sprockets, Twin FIAMM Horns, Skidmarx Bellypan, Full Micron Zeta Steel System, Cut down undertay.
Forum Problems & Information / Site Suggestions
|
|
|